diff --git a/Grbl_Esp32/Machines/lowrider_v1p2.h b/Grbl_Esp32/Machines/lowrider_v1p2.h
index eab375e2..4556c9cf 100644
--- a/Grbl_Esp32/Machines/lowrider_v1p2.h
+++ b/Grbl_Esp32/Machines/lowrider_v1p2.h
@@ -30,19 +30,19 @@
 
 #define USE_GANGED_AXES // allow two motors on an axis
 
-#define X_STEP_PIN          GPIO_NUM_27     // use Z labeled connector
-#define X_DIRECTION_PIN     GPIO_NUM_33     // use Z labeled connector
+#define Y_STEP_PIN          GPIO_NUM_27     // use Z labeled connector
+#define Y_DIRECTION_PIN     GPIO_NUM_33     // use Z labeled connector
 
-#define Y_STEP_PIN          GPIO_NUM_14
-#define Y2_STEP_PIN         GPIO_NUM_21     // ganged motor
-#define Y_DIRECTION_PIN     GPIO_NUM_25
-#define Y_AXIS_SQUARING
-
-#define Z_STEP_PIN          GPIO_NUM_12     // use X labeled connector
-#define Z2_STEP_PIN         GPIO_NUM_22     // use X labeled connector
-#define Z_DIRECTION_PIN     GPIO_NUM_26     // use X labeled connector
+#define Z_STEP_PIN          GPIO_NUM_14     // use Y labeled connector 
+#define Z2_STEP_PIN         GPIO_NUM_21     // ganged motor
+#define Z_DIRECTION_PIN     GPIO_NUM_25     // use Y labeled connector
 #define Z_AXIS_SQUARING
 
+#define X_STEP_PIN          GPIO_NUM_12     // use X labeled connector
+#define X2_STEP_PIN         GPIO_NUM_22     // ganged motor
+#define X_DIRECTION_PIN     GPIO_NUM_26     // use X labeled connector
+#define X_AXIS_SQUARING
+
 // OK to comment out to use pin for other features
 #define STEPPERS_DISABLE_PIN GPIO_NUM_13
 
@@ -55,16 +55,16 @@
 #else
     #define SPINDLE_TYPE SPINDLE_TYPE_PWM
     #define SPINDLE_OUTPUT_PIN         GPIO_NUM_16
-    #define SPINDLE_ENABLE_PIN      GPIO_NUM_32
+    #define SPINDLE_ENABLE_PIN         GPIO_NUM_32
 #endif
 
 // Note: Only uncomment this if USE_SPINDLE_RELAY is commented out.
 // Relay can be used for Spindle or Coolant
 //#define COOLANT_FLOOD_PIN             GPIO_NUM_17
 
-#define X_LIMIT_PIN             GPIO_NUM_15
-#define Y_LIMIT_PIN             GPIO_NUM_4
-#define Z_LIMIT_PIN             GPIO_NUM_17
+#define Y_LIMIT_PIN             GPIO_NUM_15
+#define Z_LIMIT_PIN             GPIO_NUM_4
+#define X_LIMIT_PIN             GPIO_NUM_17
 
 #define LIMIT_MASK              B111
 
@@ -72,6 +72,7 @@
     #define ENABLE_SOFTWARE_DEBOUNCE
 #endif
 
+#define PROBE_PIN               GPIO_NUM_35
 
 // The default value in config.h is wrong for this controller
 #ifdef INVERT_CONTROL_PIN_MASK