From ee5059b0cf918a0916fdab0aff01798e3f5c30f3 Mon Sep 17 00:00:00 2001 From: oliexdev Date: Sun, 21 Dec 2014 02:41:50 -0800 Subject: [PATCH] Updated Home (markdown) --- Home.md | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Home.md b/Home.md index 4cc6a8c..157ed00 100644 --- a/Home.md +++ b/Home.md @@ -87,8 +87,8 @@ void setup() digitalWrite(6, HIGH); Serial.begin(9600); - Serial.println("Enter AT commands:"); + BTSerial.begin(38400); } @@ -104,7 +104,7 @@ void loop() } ``` -If you successfully in the AT mode the HC-05 Bluetooth module LED blinks every 2 seconds. Open the Serial Monitor in the Arduino IDE under Tools->Serial Monitor. Change "no line ending " to "both NL & CR" found just beside the baud rate. Now you can send a test command with `AT` and you should receive `OK` if everything works fine. Following a short summary of the most important AT commands of the available [HC-05 AT Commands](https://github.com/oliexdev/openScale/raw/master/doc/hc_05/HC_05_AT_Commands.pdf): +If you successfully in the AT mode the HC-05 Bluetooth module LED blinks every 2 seconds. Open the Serial Monitor in the Arduino IDE under Tools->Serial Monitor. Change "no line ending " to "both NL & CR" found just beside the baud rate. Now you can send a test command with `AT` if everything works fine you should receive a `OK`. Following a short summary of the most important AT commands of the available [HC-05 AT Commands](https://github.com/oliexdev/openScale/raw/master/doc/hc_05/HC_05_AT_Commands.pdf): | AT command | Response | Parameter | Comment | |:----------:|:--------:|:---------:|:-------:|