Mendel90/sturdy/bom/spool_holder_assembly.txt

spool_holder_assembly:
Vitamins:
  4 Ball bearing 608 8mm x 22mm x 7mm
  4 M8 cap screw x 30mm
  4 Nyloc nut M8
  2 No6 pan wood screw x 16mm
  1 PTFE tubing OD 4.6mm ID 3.84mm x 750mm
  2 Washer M4 x 9mm x 0.8mm
  8 Washer M8 x 17mm x 1.6mm
  4 Washer M8 x 30mm x 1.5mm
  2 Star washer M4 x 0.8mm

Printed:
  1 dust_filter.stl
  2 spool_bracket_female.stl
  2 spool_bracket_male.stl
  2 spool_holder_p_clip.stl
This version used for the kits 1-6 at the GIST FOTM. Z axis length increased to 200mm. Added the Dibond variant that uses nuts in the parts instead of tapped holes. Added a ducted fan to the X carriage. Added a spool holder and filament dust wiper. Default hot end is now J-Head MK4. Default electronics is now Melzi plus ATX PSU on the mendel and dibond versions. The right hand stay has been moved inwards and base corner radius reduced to allow and ATX PSU to be mounted inboard. Mounting brackets for ATX PSU added. The electronics are now above the PSU. Mains inlet cover added for non ATX PSUs. Dummy load resistors added for ATX PSU. The extruder now has a groove mount for the JHead. Extruder connector increased from 9 way to 15 way to allow an IDC socket. The extruder ribbon cable is now 14 way to allow three wires for the heater. Added an extruder break out PCB. Wade's idler bracket now a bit wider to allow more tolerance on the length of the axle. Extruder motor screws now longer and hex head. The hobbed bolt now has two nuts and a star washer instead of one nut and a spring. Increased the bed ribbon cable to 26 way to make it standard size. Y carriage made a bit smaller. Thermistor added to the bed assembly. Bed cooling fan made an optional extra. Made the Z top limit switch the default. The X idler now has two bearings. Lead nuts now brass. Added metal pulleys as an option. T2.5 belts added as an option. Nut traps added to the Y carrige ribbon clamp. Corner shields and support material added to X motor bracket. Belt length calculations more accurate. Axis limit switch positions and overtravel optimised. Washer sizes tweaked. Ziptie length tweaked. PVC tubing diameter changed. 2012-11-15 17:45:30 +00:00			`spool_holder_assembly:`
			`Vitamins:`
			`4 Ball bearing 608 8mm x 22mm x 7mm`
			`4 M8 cap screw x 30mm`
			`4 Nyloc nut M8`
			`2 No6 pan wood screw x 16mm`
			`1 PTFE tubing OD 4.6mm ID 3.84mm x 750mm`
			`2 Washer M4 x 9mm x 0.8mm`
			`8 Washer M8 x 17mm x 1.6mm`
			`4 Washer M8 x 30mm x 1.5mm`
			`2 Star washer M4 x 0.8mm`

			`Printed:`
			`1 dust_filter.stl`
			`2 spool_bracket_female.stl`
			`2 spool_bracket_male.stl`
			`2 spool_holder_p_clip.stl`